Top Frame
Everything you need to print for THE 100 top frame.
v1.0
Parts List
These parts are required regardless of which hotend you’re using.
More Info
Belt Fastener
Printing details
- Qty: 2
- Filament (length/weight): 2.7m / 8.2g
- Supports: No
Notes
None
Top Connector Back 1
Printing details
- Qty: 1
- Filament (length/weight): 4.7m/ 14g
- Supports:
Notes
None
Top Connector Back 2
Printing details
- Qty: 1
- Filament (length/weight): 4.3m / 12.7g
- Supports: No
Notes
None
Top Connector Top 1
Printing details
- Qty: 1
- Filament (length/weight): 9.1m / 27.2g
- Supports: No
Notes
None
Top Connector Top 2
Printing details
- Qty: 1
- Filament (length/weight): 9.1m / 27.2g
- Supports: No
Notes
None
Top Connector Side 1
Printing details
- Qty: 4
- Filament (length/weight): 6.7m / 20.1g
- Supports: No
Notes
None
Top Connector Side 2
Printing details
- Qty: 4
- Filament (length/weight): 3.9m / 11.6g
- Supports: No
Notes
None
Top Rod Holder
Printing details
- Qty: 2
- Filament (length/weight): 1.9m / 5.6g
- Supports: Yes
Notes
Supports in the screw holes touching the build plate.
Top Back-Left
Printing details
- Qty: 1
- Filament (length/weight): 104m / 310g
- Supports: Yes
Notes
You may be able to print this without supports if your printer can bridge over the square where the motor goes. I recommend printing this piece with a brim to prevent warping.
Top Back-Right
Printing details
- Qty: 1
- Filament (length/weight): 104m / 310g
- Supports: Yes
Notes
You may be able to print this without supports if your printer can bridge over the square where the motor goes. I recommend printing this piece with a brim to prevent warping.
Top Front-Left
Printing details
- Qty: 1
- Filament (length/weight): 91.2m / 272g
- Supports: Yes
Notes
The only support needed is a single screw hole that touches the build plate. I recommend printing this piece with a brim to prevent warping.
Top Front-Right
Printing details
- Qty: 1
- Filament (length/weight): 91.2m / 272g
- Supports:
Notes
The only support needed is a single screw hole that touches the build plate. I recommend printing this piece with a brim to prevent warping.