THE 100 Toolhead #

Everything you need to print for THE 100 toolhead.

There are five total parts you need to print for the toolhead. Three are the same for all hotends and two vary depending on if you’re using the CHC or CHC Pro hotend.

v1.0 #

Parts List - All Hotends #

These parts are required regardless of which hotend you’re using.

Parts List - CHC Pro Only #

Print these if you’re using the CHC Pro as your hotend.

Parts List - CHC Only #

Print these if you’re using the CHC (not pro) as your hotend.

More Info #

Adapter Plate #

Printing details #

• Qty: 1
• Filament (length/weight): 1m / 2.9g
• Supports: No

Notes #

None

Rod Carriage #

Printing details #

• Qty: 1
• Filament (length/weight): 8.6m / 25.7g
• Supports: Yes

Notes #

I rarely struggle with bed adhesion but out of the entire printer, this is the only one that gave me trouble. It kept getting knocked off. I ended up having to use a brim and enable z-hop to prevent it. Make sure supports are only used on the one end and that you don’t generate supports through the square holes in the middle where the belts will go in the future.

Fanhead #

Printing details #

• Qty: 1
• Filament (length/weight): 20.7m / 61.6g
• Supports: Yes

Notes #

Only generate suports under the curved parts against the build plate. This piece is printed upside down to limit the amount of supports that need generated while still maintaining the openings for the airways.

CHC Pro Mount #

Printing details #

• Qty: 1
• Filament (length/weight): 3.5m / 10.4g
• Supports: Yes

Notes #

None

CHC Pro Mount Front #

Printing details #

• Qty: 1
• Filament (length/weight): 0.69m / 2g
• Supports: No

Notes #

None

CHC Mount #

Printing details #

• Qty: 1
• Filament (length/weight): 3.5m / 10.4g
• Supports: Yes

Notes #

See CHC Pro Toolhead for print orientation

CHC Mount Front #

Printing details #

• Qty: 1
• Filament (length/weight): 0.66m / 1.9g
• Supports: No

Notes #

See CHC Pro Front for print orientation